
Bubbles are the fastest way to turn a crystal-clear soap cloudy. They float to the top and leave a foamy layer, or they get trapped inside the bar. The fix is cheap and simple: rubbing alcohol in a spray bottle, plus a few habits that keep bubbles from forming in the first place.
As an Amazon Associate I earn from qualifying purchases. Some links in this post are affiliate links. They cost you nothing extra and help support Koala Soap.
How to Remove Bubbles on Top of Melt and Pour Soap
Spray the surface with rubbing alcohol right after you pour. The alcohol breaks the surface tension, and the bubbles pop almost instantly.
- Fill a small fine mist spray bottle with 91% isopropyl rubbing alcohol. 99% works too.
- Pour your soap into the mold.
- Hold the bottle 6 to 8 inches away and give the top one or two light mists.
- Spray again if new bubbles rise in the next minute or two.
A fine mist works better than a stream. A heavy spray can dent the soft surface.

How to Stop Bubbles From Forming
- Stir slowly. Gently stir in fragrance and color with a small spatula or spoon. Don’t whisk or stir fast.
- Don’t overheat the base. Very hot base gets foamy and can boil. Heat in short bursts and stir between them. See the melt and pour soap temperature guide.
- Pour low and slow. Hold your cup close to the mold and pour in a steady stream down the side.
- Pre-mix powders. Mix mica, clay or titanium dioxide with a little alcohol before adding it, so you aren’t stirring hard to break up clumps.
- Spray the mold. A quick mist of alcohol in a detailed mold helps soap flow into small spaces without trapping air.
Bubbles Inside Clear Soap
Bubbles trapped inside a bar usually come from stirring too hard, pouring too fast or pouring base that has started to thicken. Pour at the right temperature, let the cup sit for a few seconds so bubbles can rise, then spray the surface before you pour.
Embeds can trap air too. Spray each embed with alcohol before you set it in the mold, and again before pouring over it.
Bubbles Between Layers
When you pour layers, spray the set layer with alcohol right before pouring the next one. It pops bubbles and helps the layers stick together, so they don’t separate later.

Can You Fix a Bar With Bubbles?
If bubbles are only on the surface, you can sometimes skim them off while the soap is still liquid, or gently plane the top of a set bar. For a bubbly bar you don’t like, you can remelt melt and pour soap and pour it again.
FAQ
What kind of alcohol do you use on melt and pour soap?
Isopropyl rubbing alcohol, 91% or 99%. Lower percentages contain more water and don’t work as well.
Is the alcohol safe to leave on soap?
Yes. It evaporates within moments and doesn’t stay in the finished bar.
Why is my clear soap cloudy?
Tiny trapped bubbles, overheating or pouring too cool can all cause cloudiness. The base matters too. See our clearest melt and pour soap base comparison.
Love making soap? Get my book!
Koala Soap Favorites has 31 of my most-loved melt and pour designs with step-by-step photos, exact amounts and a video for every recipe. It makes a sweet gift for a crafty friend, too.
See it on AmazonLook inside the book →
